Ricoh FAX2210L Operating Instructions - Page 178

Envelopes Envelope construction is critical. Envelope fold lines can vary considerably, not only between manufacturers, but also within a box from the same manufacturer. Successful printing on envelopes depends upon the quality of the envelopes. When selecting envelopes, consider the following components: • Weight: The weight of the envelope paper should not exceed 90g/m2 (24lb) or jamming may occur. • Construction: Prior to printing, envelopes should lie flat with less than 6mm (0.25in.) curl, and should not contain air. • Condition: Envelopes should not be wrinkled, nicked or otherwise damaged. • Temperature: You should use envelopes that are compatible with the heat and pressure of the machine. • Size: You should only use envelopes within the following size ranges NOTES: • Use only the manual feeder to print envelopes. • You may experience some paper jams when using any media with a length less than 140 mm (5.5 in.). This may be caused by paper that has been affected by environmental conditions. For optimum performance, make sure you are storing and handling the paper correctly. Please refer to "Paper Storage Environment" on page .12. Envelopes with Double Side Seams Double side-seams construction has vertical seams at both ends of the envelope rather than diagonal seams. This style may be more likely to wrinkle. Be sure the seam extends all the way to the corner of the envelope as illustrated below. Correct Incorrect Envelopes with Adhesive Strips or Flaps Envelopes with a peel-off adhesive strip or with more than one flap that folds over to seal must use adhesives compatible with the heat and pressure in the machine. The extra flaps and strips might cause wrinkling, creasing or even jams and may even damage the fuser. A A.13