Sanyo PLC-HF10000L Owner's Manual - Page 31

Keystone Correction Press the KEYSTONE button on the remote control to switch the Standard (for Vertical/Horizontal) /Corner correction adjustment. The Standard or Corner correction adjustment dialog box appears. Use the Point ed 7 8 buttons to correct the Standard or Corner distortion. The Standard or Corner correction adjustment can be stored (see pages 45, 52). Remote Control Basic Operation POINT buttons Standard KEYSTONE button Reduce the lower width with the Point d button. Reduce the upper width with the Point e button. Reduce the right part with Point 8 button. Reduce the left part with Point 7 button. Corner correction Press the KEYSTONE button on the remote control to switch Corner correction adjustment, press the SELECT button on the remote control to select the corner you want to adjust. Reduce the top left corner part Reduce the top right corner with the Point 8d buttons. part with the Point 7d buttons. Press the SELECT button ✔Note: • The white arrows indicate that there is no correction. • A red arrow indicates the direction of correction. • An arrow disappears at the maximum correction. • If you press and hold the KEYSTONE button for more than 3 seconds while the Standard or Corner correction dialog box is being displayed, the Standard or Corner correction adjustment will be released. • The Corner pattern can be set to Off, Red, White or Blue in the Corner pattern function. See "Keystone" on pages 45, 52. • The adjustable range is limited depending on the input signal. • Standard and Corner correction functions cannot be adjusted at the same time. If one of the functions is adjusted, and then the other one will be reset automatically. The top left corner adjustment as an example: Press the Point d button Press the SELECT button Keystone Keystone Press the SELECT button Press the SELECT button Reduce the bottom left corner part with the Point 8e buttons. Reduce the bottom right corner part with the Point 7e buttons. Keystone Press the Point 8 button 31