Sanyo PLC-HF10000L Owner's Manual - Page 97
Serial Control Interface, Operation, Functional Execution Commands
View all Sanyo PLC-HF10000L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Appendix Serial Control Interface This projector provides a function to control and monitor the projector's operations by using the RS-232C serial port. Operation 1 Connect a RS-232C serial cross cable to SERIAL PORT IN on the projector and serial port on the PC (See p.11). 2 Check the communication specifications shown right. 3 Type a functional execution command and press the Enter key. Example To select INPUT 2 port, type "C06" [CR]. Functional Execution Commands Format The command is sent from PC to the projector with the format below; "C" [Command] [CR] Command: two characters (refer to the command table below. -The projector decodes the command and returns the "ACK" with the format below; [ACK] [CR] -When the projector cannot decode the command, it returns with format below. "?" [CR] Command C00 C01 C05 C06 C07 C08 C0D C0E C0F C10 C1C C1D C3A Function Turn the projector ON Turn the projector OFF (immediately OFF) Select Input 1 Select Input 2 Select Input 3 Select Input 4 Video mute ON Video mute OFF Screen Normal Size Screen Full Size Menu ON Menu OFF Pointer RIGHT Baud rate Parity check Stop bit Flow control Data bit : 9600 / 19200 bps : none : 1 : none : 8 ✔Note: •The default of the baud rate is set to 19200 bps. If an error occurs in the communication, change the serial port and the communication speed (baud rate). •Enter with ASCII 64-byte capital characters and onebyte characters. Command C3B C3C C3D C3F C46 C47 C4A C4B C5D C5E C5F C60 C89 C8E C8F C90 C91 Function Pointer LEFT Pointer UP Pointer DOWN Enter Zoom DOWN Zoom UP Focus DOWN Focus UP Lens shift UP Lens shift DOWN Lens shift LEFT Lens shift RIGHT Auto PC Adj. Keystone UP Keystone DOWN Keystone RIGHT Keystone LEFT 97