Sennheiser EK 300 IEM G2 Instructions for Use - Page 52

ƺ ƺ ƿ To mount two transmitters into a rack: ̈ Place the two transmitters side by side onto a flat surface, their bottom sides facing upwards. ̈ Align the connecting plate Ƽ over the holes in the bottom sides of the transmitters. ƺ ̈ Secure the connecting plate Ƽ using eight of the supplied recessed head screws (M 3x6). ̈ Hook the two rack mount "ears" ƺ to the front panels of the transmitters. ̈ Secure the rack mount "ears" to the transmitters using two of the supplied recessed head screws Ƽ (M 3x6) respectively. ̈ Slide the transmitters into the 19" rack. ̈ Secure the rack mount "ears" to the rack. ƻ ƽ ƺ When mounting only one transmitter into a rack, use the connecting bar ƻ instead of the second transmitter. ̈ Hook the two rack mount "ears" ƺ to the front panels of the transmitter. ̈ Secure the rack mount "ears" to the transmitter using two of the supplied recessed head screws (M 3x6) respectively. ̈ Secure the connecting bar ƻ to one of the rack mount "ears" ƺ using two of the supplied recessed head screws (M 6x10). ̈ If you are not front mounting the antennas, insert the two covering plugs ƽ into the antenna holes of the connecting bar. ̈ Slide the transmitter into the 19" rack. ̈ Secure the rack mount "ears" to the rack. ƾ ƻ To mount the transmitter's antenna connection to the front of the GA 2 rack adapter using the AM 2 antenna mount: ̈ Screw the BNC socket ƾ of the BNC extension cables to the connecting bar ƻ using the supplied plain ƹ washer and nut. ̈ Connect the BNC connector ƿ to the BNC socket Ƹ at the rear of the transmitter. ̈ Slide the transmitter into the 19" rack. ̈ Secure the rack mount "ears" to the rack. ̈ Connect the telescopic antenna ƹ to the BNC socket ƾ. ̈ Pull the end cap to extend the telescopic antenna. 50