Sharp AX-700S AX-700S Operation Manual - Page 37
Troubleshooting Chart
View all Sharp AX-700S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
TROUBLESHOOTING CHART MESSAGE ON DISPLAY INFORMATION DRAIN WATER MESSAGE NOW COOLING PREPARING STEAM ACTION After cooking or if water has been left in the steam generator for more than 15 hours, this message will be displayed. Remove the reservoir. Check that the base tray is on the oven floor. Press START. If "NOW COOLING" is displayed, see next section. Wait until the water has cooled in the steam generator. When "NOW COOLING" disappears, the water will be drained automatically. It takes a maximum of 30 minutes to cool and then drain after cooking. When START is pressed, this message may appear. Count down begins when the message disappears. The followings situations are normal and are not signs that the oven is malfunctioning. QUESTION / SITUATION ANSWER Control panel / power supply The display is black / blank. * Check that power plug is connected to a suitable wall outlet. See page 4. * Check that fuse or circuit breaker is functioning properly. If not, correct. * Disconnect the oven from the power source, wait one minute and then plug into the wall outlet. If the problem exists, consult a Sharp Authorized Servicer. The display is fine but * Open the door and close. Is the oven light off? Press START will not function START again. when pressed. * If the display says, "Wait until oven is cool.", be sure to wait until it disappears and then press START. Electrical power supply is in- The cooking program will be cancelled. Continue to cook terrupted during cooking. using the manual settings. Check food carefully as it cooks. Oven light is off during Normal operation to prevent bread dough from drying PROOF. on the surface. Oven light is off when door Oven light lights for maximum 5 minutes when door is is opened. opened. When either dial is turned, Follow step-by-step instructions for draining the water "DRAIN WATER" is displayed. on page 13. STOP/CLEAR pad cannot During draining, STOP/CLEAR pad is locked. Wait for be entered during draining. 15 seconds and try again. 35