Sharp HT-DD5000 HTDD5000 Operation Manual - Page 3

CONTENTS Page ACCESSORIES 2 PRECAUTIONS 2 PREPARATION FOR USE 3-7 EXTERNAL UNIT CONNECTION 8-11 SOUND CONTROL 11-12 DOLBY DIGITAL 13 SURROUND EFFECT CONTROL 14-15 ACCESSORIES Page SET UP 16-20 RADIO OPERATION 21-22 HOW TO USE THE BUILT-IN TIMER 23-24 HEADPHONES 24 DESCRIPTION OF TERMINOLOGY 25 MAINTENANCE 26 SPECIFICATIONS 26 CONSUMER LIMITED WARRANTY Back cover Remote control x 1 (RRMCG0004SJSA) FM antenna x 1 (QANTW0001SJZZ) AM loop antenna x 1 (QANTL0001SJZZ) Front speaker wire × 2 (QCNWH0001SJZZ) Center speaker wire × 1 (QCNWH0001SJZZ) Sub woofer wire × 1 (QCNWH0001SJZZ) Surround speaker wire × 2 (QCNWH0002SJZZ) RCA cord x 1 (QCNWG0003SJZZ) Coaxial digital cord x 1 (QCNWG0004SJZZ) Note: Parts and accessories mentioned in this operation manual other than those in the drawing are not included. PRECAUTIONS s General q Please ensure that the equipment is positioned in a well q If the unit does not work properly while in use, disconnect ventilated area and ensure that there is at least 4" (10 cm) of free space along the sides, top and back of the the AC power cord from the AC outlet. Plug the AC power cord back in, and then set the POWER button on the equipment. main unit to ON. q Do not use oil, solvents, gasoline, paint thinners or in- q If an electrical storm is taking place near you, it is sug- secticides on the unit. gested that you disconnect the AC power cord from the q Do not expose the unit to moisture, to temperatures AC outlet for safety. higher than 140˚F (60˚C) or to extreme low temperatures. q Keep the unit away from direct sunlight, strong magnetic fields, excessive dust, humidity and electronic/electrical equipment (home computers, facsimiles, etc.) which generates electrical noise. Warning: The voltage used must be the same as that specified on this unit. Using this product with a higher voltage other than which is specified is dangerous and may result in a fire or other type of accident causing damage. SHARP will not be q Hold the AC power plug by the head when removing it held responsible for any damage resulting from use of this from the AC outlet, since pulling the cord can damage unit with a voltage other than that which is specified. internal wires. q Do not remove the outer cover, as this may result in s Volume control electric shock. Refer internal service to your local SHARP service facility. q Use the unit on a firm, level surface free from vibration, and do not place anything on the top of the unit. q If "ERROR" appears or no sound is heard, set the The sound level at a given volume setting depends on a combination of speaker efficiency, location and various other factors. It is advisable to avoid exposure to high volume levels, which occur while turning the unit on with the volume control setting POWER button on the main unit to OFF. About 5 sec- up high, or while continually listening at high volumes. onds later, turn the power back on. 2 HT-DD5000(SEC) TINSE0009SJZZ