Sharp VL-NZ150U VLNZ100U|VLNZ150U Operation Manual - Page 29

Preparation Installing the Lithium Battery Installing The supplied lithium battery is used to store the memory of the date and time settings. 1 Slide the cassette compartment door release and open the cassette compartment door. Note: • The cassette holder will extend and open when the camcorder is connected to a power source. Be sure to close the cassette holder before proceeding to the next step (see page 12). 2 Pull out the lithium battery holder using a pointed object such as the tip of a ballpoint pen. Lithium battery holder Removing Perform steps 1 and 2 above, then lift out the battery from the battery holder. Notes on the Use of the Lithium battery REPLACE BATTERY WITH TOSHIBA, MATSUSHITA OR HITACHI MAXELL TYPE CR2025 ONLY. USE OF A DIFFERENT BATTERY MAY PRESENT A RISK OF FIRE OR EXPLOSION. X KEEP THIS BATTERY AWAY FROM CHILDREN. IF SWALLOWED, CONSULT A PHYSICIAN IMMEDIATELY FOR EMERGENCY TREATMENT. Z BATTERY MAY EXPLODE IF MISUSED OR INSTALLED WITH POLARITY REVERSED. DO NOT RECHARGE, DISASSEMBLE OR DISPOSE OF IN FIRE. • Do not short-circuit, recharge, disassemble, or heat the lithium battery. • Should the lithium battery leak, wipe the battery compartment clean, and then insert a new battery. • The lithium battery will last about one year under normal usage. 3 Insert the lithium battery into the "m" mark battery holder with the H side of the battery facing the m side of the holder. 4 Push the battery holder back into position. Press the W mark gently, then close the cassette compartment door by pressing the center until it clicks into place. 14