Sony CCD-FX310 Primary User Manual - Page 24

Identifying the Parts Wireless Remote Commander 2 4 Inside the Viewfinder 0 [] L., PLAY (play back) button [T N REW (rewind) button 0 6J I! STOP button 7 0 El II PAUSE button 0 ▪ DATA SCREEN button. 9 FS] HOLD switch" W START/STOP button fir FF M (fast forward) button ▪ Power zoom button [tel le SLOW (slow playback) button. 0 Note The • indicates the funcane which are operable only with Inc commander KI - M] PI - f0 ta] (PI [a] Focus is maintained (P) [b] BACK LIGHT is pressed 9/1) tel PROGRAM AE setting (17, K., p ) [dl Power zoom indicator [e] FADER is pressed [f] "Exchange battery' (L7) tat Moisture has condensed (NU [h] Lights up during recording When blinking: "Exchange battery or tape" [i] Playback mode (LP) Pt St tkt lit fm] ni tel tel Irl tat w Tape transport mode [k] Tape counter Remaining time of tape [In] ZERO MEM is pressed [n] "Exchange tape or no tape Inside" (WW) [0] "Trouble has occurred" (B.) "Clean video heads" (0) [p] Remaining capacity of a battery tgl Age Date or Time [a] "Replace lithium battery" (4.4) Trouble Check If you run into any problems during operation, use the following table to troubleshoot the problem. Should the difficulty persist. unplug the unit and contact your Sony dealer or local authorized Sony service facility. Symptom The power does not turn The power turns off The battery pack is quickly discharged. The START/STOP button does not operate. The taps cannot be removed from the compartment. No function except for tape ejection works. The tape does not move when a tape transport button is pressed. The autolocusing function does not work. The image on the viewfinder screen is not clear. A vertical band appears when a subject such as lights or a candle flame is shot against a dark background. The playback picture is nor clear The picture is noisy CAM* The battery is not attached The battery is used up. The AC power adaptor is not connected to a wall outlet. While being operated in CAMERA mode. the camcorder has been in the pause mode for more than 5 minutes. The battery is used up. The ambient temperature is too low. The battery pack has not been charged fully. The tape is affixed to the drum. The tape is al its end. The POWER switch is set to VTR. The tab on the tape is out (red) The battery is used up. Moisture condensation has occurred. (See page 39 ) The POWER switch is set to CAMERA or OFF. The tape is at its end. FOCUS HOLD switch is set to the direction of the arrow (See page 3O) The viewfinder lens is not adjusted. The contrast between the subject and background is too high, the camera is not malfunctioning. EDIT is set in the direction of the arrow. The channel or input for the camcorder is not selected on the TV. The video heads may be contaminated. Corrective actions Attach the battery. Use a charged battery. Conned the adaptor to a wall outlet. Turn down the STANDBY switch, and turn it up again. Use a charged battery. Charge the battery pack again. Eject the tape. Rewind the rape or use a new one. Set It to CAMERA Use a new tape or slide the tab. Use a charged battery or the AC power adaptor. Remove the tape and don t use the camcorder for at least an hour. Set it to PLAYER Rewind the tape or use a new one. Set the FOCUS HOLD switch to the opposite direction of the arrow. Adjust the viewfinder lens. Set EDIT in the opposite direction of the arrow. Select correctly. Clean the heads using the Sony V8.25CLH (See page 40) cleaning cassette. 49 Additional tntormation