Sony DSC-W55/B Cyber-shot® Handbook - Page 90

Battery pack and power, Shooting still images/movies, The battery cannot be charged. - troubleshooting

Page 90 highlights

Troubleshooting Battery pack and power The battery pack cannot be installed. • Install the battery pack correctly using the tip of the battery pack to push the battery eject lever toward the bottom of the camera. Cannot turn on the camera. • Install the battery pack correctly. • The battery pack is discharged. Install charged battery pack. • The battery pack is dead (page 106). Replace it with a new one. • Use a recommended battery pack. The power turns off suddenly. • If you do not operate the camera for about three minutes while the power is on, the camera turns off automatically to prevent wearing down the battery pack. Turn on the camera again. • The battery pack is dead (page 106). Replace it with a new one. The battery remaining indicator is incorrect. • This phenomenon occurs when you use the camera in an extremely hot or cold location. • The displayed battery remaining differs from the current one. Fully discharge and then charge the battery pack to correct the display. • The battery pack is discharged. Install the charged battery pack. • The battery pack is dead (page 106). Replace it with a new one. The battery cannot be charged. • You cannot charge the battery with the AC adaptor (not supplied). Shooting still images/movies The screen does not turn on even when the power is turned on. • Turn on the screen (page 16). Your camera cannot record images. • Check the free capacity of the internal memory or "Memory Stick Duo". If it is full, do one of the following: - Delete unnecessary images (page 28). - Change the "Memory Stick Duo". • You are using the "Memory Stick Duo" with the write-protect switch, and the switch is set to the LOCK position. Set the switch to the recording position (page 104). • You cannot record images while charging the flash. • Set the mode dial to a position other than when shooting still images. • Set the mode dial to when shooting movies. 90

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111

90
Troubleshooting
The battery pack cannot be installed.
Install the battery pack correctly using the tip of the battery pack to push the battery eject
lever toward the bottom of the camera.
Cannot turn on the camera.
Install the battery pack correctly.
The battery pack is discharged. Install charged battery pack.
The battery pack is dead (page 106). Replace it with a new one.
Use a recommended battery pack.
The power turns off suddenly.
If you do not operate the camera for about three minutes while the power is on, the camera
turns off automatically to prevent wearing down the battery pack. Turn on the camera again.
The battery pack is dead (page 106). Replace it with a new one.
The battery remaining indicator is incorrect.
This phenomenon occurs when you use the camera in an extremely hot or cold location.
The displayed battery remaining differs from the current one. Fully discharge and then charge
the battery pack to correct the display.
The battery pack is discharged. Install the charged battery pack.
The battery pack is dead (page 106). Replace it with a new one.
The battery cannot be charged.
You cannot charge the battery with the AC adaptor (not supplied).
The screen does not turn on even when the power is turned on.
Turn on the screen (page 16).
Your camera cannot record images.
Check the free capacity of the internal memory or “Memory Stick Duo”. If it is full, do one of
the following:
Delete unnecessary images (page 28).
Change the “Memory Stick Duo”.
You are using the “Memory Stick Duo” with the write-protect switch, and the switch is set to
the LOCK position. Set the switch to the recording position (page 104).
You cannot record images while charging the flash.
Set the mode dial to a position other than
when shooting still images.
Set the mode dial to
when shooting movies.
Battery pack and power
Shooting still images/movies