Sony FDR-AX1 Operating Guide - Page 57
Removing dust from inside the, viewfinder, Remove the eye piece of the viewfinder.
View all Sony FDR-AX1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
LCD screen • Do not exert excessive pressure on the LCD screen, as it may cause damage. • If your camcorder is used in a cold place, a residual image may appear on the LCD screen. This is not a malfunction. • While using your camcorder, the back of the LCD screen may heat up. This is not a malfunction. To clean the LCD screen The surface of the LCD screen is coated. If you scratch the surface, the coating may be come off. Mind the following points when cleaning and handling it. • If hand grease or hand cream remains on the screen, the coating comes off more easily. Wipe it early. • The coating may be scratched if you wipe the screen with a tissue, etc. • Remove the dust or sand with a blower, etc. before wiping the dirt. • Use a soft cloth (a cloth for glasses, etc.) gently to clean the dirt. On handling the casing • If the casing is soiled, clean the camcorder body with a soft cloth lightly moistened with water, and then wipe the casing with a dry soft cloth. • Avoid the following to avoid damage to the finish. -Using chemicals such as thinner, benzine, alcohol, chemical cloths, repellent, insecticide and sunscreen. -Handling with above substances on your hands. -Leaving the casing in contact with rubber or vinyl objects for a long period of time. About care and storage of the lens • Wipe the surface of the lens clean with a soft cloth in the following instances: -When there are fingerprints on the lens surface. -In hot or humid locations -When the lens is exposed to salty air such as at the seaside. • Store in a well-ventilated location subject to little dirt or dust. • To prevent mold, periodically clean the lens as described above. On charging the pre-installed rechargeable battery Your camcorder has a pre-installed rechargeable battery to retain the date, time, and other settings even when the POWER switch is set to OFF. The pre-installed rechargeable battery is always charged while your camcorder is connected to the wall outlet (wall socket) via the AC Adaptor or while the battery pack is attached. The rechargeable battery will be fully discharged in about 3 months if you do not use your camcorder at all without the AC Adaptor connected or the battery pack attached. Use your camcorder after charging the pre-installed rechargeable battery. However, even if the pre-installed rechargeable battery is not charged, the camcorder operation will not be affected as long as you are not recording the date. Removing dust from inside the viewfinder 1 Remove the eye piece of the viewfinder. Slide down the viewfinder release lever and hold it at the position (1), then lift the eye piece of the viewfinder as indicated with the arrow in the illustration (2). Appendices Important Notes on Operation 57