Sony HDW1800 Installation Manual - Page 14

21. Slide the unit in and out from the rack about three times and check that the slide rails move smoothly. If they are not smoothly, demount the unit and go back to "Attaching the outer rails" (step 12). c When demounting the unit, carry it by the two persons or more. n This unit does not have the feet at this operating. Put down the unit on the floor or other, being careful not to damage the unit. 22. Push the unit in the depths of the rack. The unit is fixed to the rack by the lock mechanism. Attempt to pull the rack angles and confirm that the unit cannot be pulled out of the rack. w When installing the unit in an Outside Broadcasting van, be sure to fix the unit to the rack using the screws and ornamental washers supplied with the rack mount kit. Tightening torque: 120 x 10_2 N . m {12.2 kgf . cm} n When the unit is not fixed to the rack or the clearances between the rack angle and rack are existed, it is necessary to perform the adjustment for the lock mechanism. Refer to the RMM-131 installation guide for more detailed information. Release button Ornamental washer RK5 x 14 RK5 x 14 Release button Ornamental washer 1-8 (E) HDW-1800/D1800