Sony HDW1800 Installation Manual - Page 23

1-11. Operation Mode Settings When turning on the POWER switch for the first time or after executing "M49: RESET ALL SETUP" in the maintenance mode, the mode for selecting a destination (J or SYL) appears. Select a destination following the operation procedure of the destination selection mode. Once a destination is selected, this mode does not appear when the POWER switch is turned on and the unit operates with the selected destination. m . Be sure to select a destination before use. If no destination is selected, the unit will not perform the playback and recording operations correctly even though these operations are enabled. . Destination: "J" is for the models for Japan, and "SYL" is for the models for the countries other than Japan. 1-11-1. Operation Procedure of Destination Selection Mode 1. When no destination has not been selected, turning on the POWER switch displays the following indication in the menu display area of the control panel. 2. Pressing the F3 (_) or F4 (+) button selects the destination 50 : SYL, 59.94 : SYL or 59.94: J. DESTINATION SETTING * NO-SET 50:SYL 59.94:SYL 59.94:J Select DESTINATION. Push SET button. 3. Press the F9 (SET) button. . Pressing the F9 (SET) button accepts the selected destination. . Screen 2 appears after Screen 1 is displayed for about 10 seconds as shown in the figure. Then turn off the POWER switch. Screen 1 DESTINATION SETTING INITIALIZING... HDW-1800/D1800 Screen 2 About 10 seconds DESTINATION SET COMPLETE 59.94:SYL TURN OFF/ON POWER !! To return the destination to the "NO-SET" status: Reset all the unit settings to the factory settings using "M49: RESET ALL SETUP" of the maintenance mode. For details about the maintenance mode, refer to Section 3 in the Maintenance Manual Volume-1. n All the settings, including the setup menu, are reset. 1-17 (E)