Sony MDS-JE470 Operating Instructions - Page 11
Recording to MDs - program
View all Sony MDS-JE470 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Recording to MDs Recording to MDs Recording to an MD If the MD has been partially recorded, recording starts after the recorded tracks. 1 Turn on the amplifier and program source, and select the source on the amplifier. 2 Press ?/1 to turn on the deck. The STANDBY indicator turns off. 3 Load a recordable MD into the slot (page 20). 4 Press INPUT repeatedly to select the input jacks (connector) connected to the program source. When the source is connected to the Set INPUT to DIGITAL OPTICAL IN1 or OPT1 or OPT2 IN2 connector DIGITAL OPTICAL IN connector OPT or D-IN DIGITAL COAXIAL IN jack1) COAX ANALOG IN jacks ANALOG or A-IN 1) MDS-JE770 European model only 5 Press REC z. The deck changes to recording pause. 6 If necessary, adjust the recording level. For details, see "Adjusting the recording level" on page 16. 7 Press H or X. Recording starts. 8 Start playing the program source. Operations you may want to do during recording To Stop recording Pause recording Resume recording after pausing2) Eject the MD Press x X H or X EJECT A after stopping recording 2) The track number increases by one. To change the display while recording Press LEVEL/DISPLAY/CHAR (or DISPLAY) repeatedly to change the display. Each press of the button changes the display cyclically as follows: MDS-JE770 Track number and recorded time of the current track t Level of the input signal (setting value of the recording level) t Sampling frequency indication3) 3) "FS -- kHz" appears while the analog signal is input. MDS-JE470 Track number and recorded time of the current track t Remaining recordable time4) on the MD t Level of the input signal t Track name5) 4) Time shown in the display differs depending on the setting of REC MODE. 5) "No Name" appears when the track has no name. 11