Sony MDS-JE470 Operating Instructions - Page 36

Fading in and fading out You can use Fade-in Play to gradually increase the signal level to the ANALOG OUT jacks and the PHONES jack (MDS-JE770 only) at the start of playing. Fade-out Play gradually decreases the signal level at the end of playing. Fade-in Recording gradually increases the signal level at the start of recording. Fade-out Recording gradually decreases the signal level at the end of recording. Note The level of the signal output from the DIGITAL OUT connector does not change during Fade-in Play or Fade-out Play. Fade-in Play and Fade-in Recording During play pause (for Fade-in Play) or recording pause (for Fade-in Recording), press FADER on the remote. b flashes in the display and the deck performs Fade-in Play or Fade-in Recording for five seconds (factory setting) until the counter reaches "0.0s." Fade-out Play and Fade-out Recording During play (for Fade-out Play) or recording (for Fade-out Recording), press FADER on the remote. B flashes in the display and the deck performs Fade-out Play or Fade-out Recording for five seconds (factory setting) until the counter reaches "0.0s," then pauses. 36 Tip Do the following procedure to specify the fade-in or fade-out duration for playback or recording. 1 While the deck is stopped or playing, or paused, press MENU/NO. 2 Turn AMS (or press ./> repeatedly) until "Setup?" appears, then press AMS or YES. 3 Turn AMS (or press ./> repeatedly) to select the setting, then press AMS or YES. To change the duration of Select Fade-in Play/Recording F.in Fade-out Play/Recording F.out 4 Turn AMS (or press ./> repeatedly) to select the duration, then press AMS or YES. Both the Fade-in and Fade-out durations can be set in 0.1 second steps. 5 Press MENU/NO. Falling asleep to music - Sleep Timer You can set the deck so that it turns off automatically after a specified duration. 1 While the deck is stopped or playing, press MENU/NO. 2 Turn AMS (or press ./> repeatedly) until "Setup?" appears, then press AMS or YES. 3 Turn AMS (or press ./> repeatedly) until "Sleep Off" appears in the display, then press AMS or YES. 4 Turn AMS (or press ./> repeatedly) to select the setting, then press AMS or YES. To Select Turn on Sleep Timer Sleep On1) Turn off Sleep Timer Sleep Off (factory setting) 1) For MDS-JE470, the deck turns off automatically after 60 minutes. Press MENU/ NO. For MDS-JE770, do the following. 5 Turn AMS (or press ./> repeatedly) until "Sleep 60min" appears in the display, then press AMS or YES.