Sony MDS-JE470 Operating Instructions - Page 34

Changing the recorded level after recording (continued) Fade-in and Fade-out Recording 1 While the deck is stopped, playing, or paused, press MENU/NO. "Edit Menu" appears in the display. 2 Turn AMS (or press ./> repeatedly) until "S.F Edit?" appears, then press AMS or YES. 3 Turn AMS (or press ./> repeatedly) until "Fade In?" or "Fade Out?" appears, then press AMS or YES. 4 Turn AMS (or press ./> repeatedly) until the track number you want to change the recording level appears, then press AMS or YES. "Time 5.0s" appears in the display. 5 While monitoring the sound, turn AMS (or press ./> repeatedly) to change the Fade-in or Fade-out Recording time. The deck plays the portion that will be recorded over using Fade-in or Fade-out Recording. You can set the time at any value between 1 second and 15 seconds, in 0.1 second increments. You cannot set the time longer than the track. 6 Press AMS or YES. "(S.F) Edit OK?" appears in the display. 7 Press AMS or YES again. The deck starts recording over the existing track. "S.F Edit(:) ** %" appears while the track is being recorded. When the recording finishes, "Complete!" appears. To cancel the operation Press MENU/NO or x in steps 1 to 6. If you press AMS or YES in step 7 and recording starts, you cannot interrupt the operation. Notes • Do not disconnect the AC power cord or move the deck while recording is in progress. This may damage the recording data preventing recording from being performed properly. • You cannot change the recorded level of a track recorded in LP2 or LP4 Stereo mode. 34 • Do not use an MD that is damaged or dirty. This may prevent recording data from being recorded properly. • Repeatedly changing the recording level results in poor sound quality. • The recording level will not return to the exact original level once the recording level has been changed even if it returned to the original level. • The recording level cannot be changed while the timer is activated. • You cannot undo any S.F edit operation with the Undo Function. Undoing the last edit - UNDO You can undo the last edit operation and restore the contents of the MD to the condition that existed before the operation. Note, however, that you cannot undo an edit operation if you perform any of the following operations after the edit: • Start recording. • Press MUSIC SYNC on the remote. • Change the recorded level after recording (S.F Edit). • Turn off the deck or eject the MD. • Disconnect the AC power cord. 1 While the deck is stopped, playing, or paused, press MENU/NO. "Edit Menu" appears in the display. 2 Turn AMS (or press ./> repeatedly) until "Undo?" appears. "Undo?" does not appear if no editing has been done. 3 Press AMS or YES. One of the messages appears depending on the last edit operation. 4 Press AMS or YES. "Complete!" appears.