Sony MDSJE320 Service Manual - Page 14
Operating the Continuous Playback Mode, Operating the Continuous Recording Mode, 5-3. Non- - not ejecting
UPC - 027242541344
View all Sony MDSJE320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
4-5-1. Operating the Continuous Playback Mode 1. Entering the continuous playback mode 1 Set the disc in the unit. (Whichever recordable discs or discs for playback only are available.) 2 Rotate the AMS knob and display "CPLAY MODE". 3 Press the YES button to change the display to "CPLAY MID". 4 When access completes, the display changes to "C1 = AD = ". Note : The numbers " " displayed show you error rates and ADER. 2. Changing the parts to be played back 1 Press the YES button during continuous playback to change the display as below. "CPLAY MID" n "CPLAY OUT"n "CPLAY IN" 4 When pressed another time, the parts to be played back can be moved. 2 When access completes, the display changes to "C1 = AD = ". Note : The numbers " " displayed show you error rates and ADER. 3. Ending the continuous playback mode 1 Press the EDIT/NO button. The display will change to "CPLAY MODE". 2 Press the §EJECT button to remove the disc. Note : The playback start addresses for IN, MID, and OUT are as follows. In case you want to display the address of the playback position on the display, press the DISPLAY/CHAR button and display "CPLAY ( )". IN 40h cluster MID 300h cluster OUT 700h cluster 4-5-2. Operating the Continuous Recording Mode 1. Entering the continuous recording mode 1 Set a recordable disc in the unit. (Refer to Note 3) 2 Rotate the AMS knob and display "CREC MODE". 3 Press the YES button to change the display to "CREC MID". 4 When access completes, the display changes to "CREC ( )" and REC lights up. Note : The numbers " " displayed shows you the recording position addresses. 2. Changing the parts to be recorded 1 When the YES button is pressed during continuous recording, the display changes as below. "CPLAY MID" n "CPLAY OUT"n "CPLAY IN" 4 When pressed another time, the parts to be recorded can be changed. REC goes off. 2 When access completes, the display changes to "CREC ( )" and REC lights up. Note : The numbers " " displayed shows you the recording position addresses. 3. Ending the continuous recording mode 1 Press the EDIT/NO button. The display changes to "CREC MODE" and REC goes off. 2 Press the §EJECT button to remove the disc. Note 1 : The recording start addresses for IN, MID, and OUT are as follows. IN 40h cluster MID 300h cluster OUT 700h cluster Note 2 : The EDIT/NO button can be used to stop recording anytime. Note 3 : During the test mode, the erasing-protection tab will not be detected. Therefore be careful not to set the continuous recording mode when a disc not to be erased is set in the unit. Note 4 : Do not perform continuous recording for long periods of time above 5 minutes. Note 5 : During continuous recording, be careful not to apply vibration. 4-5-3. Non-Volatile Memory Mode This mode reads and writes the contents of the non-volatile memory. It is not used in servicing. If set accidentally, press the EDIT/NO button immediately to exit it. - 14 -