Sony MEX-N4100BT Operating Instructions - Page 9
Connecting with a paired BLUETOOTH, device, Connecting with an iPhone/iPod, BLUETOOTH Auto Pairing - bluetooth pairing iphone
![]() |
View all Sony MEX-N4100BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
To start playback For details, see "Playing a BLUETOOTH Device" (page 13). To cancel pairing Perform step 2 to cancel the pairing mode after this unit and the BLUETOOTH device are paired. Connecting with a paired BLUETOOTH device To use a paired device, connection with this unit is required. Some paired devices will connect automatically. 1 Press CALL, rotate the control dial to select [SET BT SIGNL], then press it. Make sure that lights up. 2 Activate the BLUETOOTH function on the BLUETOOTH device. 3 Operate the BLUETOOTH device to connect to this unit. or lights up. Icons in the display: Lights up when handsfree calling is available by enabling the HFP (Handsfree Profile). Lights up when the audio device is playable by enabling the A2DP (Advanced Audio Distribution Profile). Indicates the signal strength status of connected cellular phone. To connect the last-connected device from this unit Activate the BLUETOOTH function on the BLUETOOTH device. Press SRC, then select [BT PHONE] or [BT AUDIO]. Press ENTER to connect with the cellular phone, or PAUSE to connect with the audio device. Note While streaming BLUETOOTH audio, you cannot connect from this unit to the cellular phone. Connect from the cellular phone to this unit instead. Tip With BLUETOOTH signal on: when the ignition is turned to on, this unit reconnects automatically to the lastconnected cellular phone. To install the microphone For details, see "Installing the microphone (MEXN5100BT only)" (page 35). Connecting with an iPhone/iPod (BLUETOOTH Auto Pairing) When an iPhone/iPod with iOS5 or later installed is connected to the USB port, the unit is paired and connected with the iPhone/iPod automatically. To enable BLUETOOTH Auto Pairing, make sure [AUTOPAIR] in [BT] is set to [ON] (page 22). 1 Activate the BLUETOOTH function on the iPhone/iPod. 2 Connect an iPhone/iPod to the USB port. Make sure that lights up on the display of the unit. Notes BLUETOOTH Auto Pairing is not possible if the unit is already connected to another BLUETOOTH device. In this case, disconnect the other device, then connect the iPhone/iPod again. If BLUETOOTH Auto Pairing is not established, see "Preparing a BLUETOOTH Device" for details (page 8). 9GB
![](/manual_guide/products/sony-mexn5100bt-operating-instructions-2c1039c/9.png)