Sony STR-DN1070 Operating Instructions - Page 35

Preparation What you can do with Easy Setup By performing Easy Setup, you can complete: 1: Selecting the language 2: Setting the speakers Check your speaker system and perform Auto Calibration according to the configuration and arrangement of your speaker system. 3: Performing Internet settings Select the network connection method and configure settings to connect the receiver to the network.  Connect the supplied calibration microphone to CALIBRATION MIC jack. Set up the calibration microphone at your listening position. Auto Calibration Before you perform Auto Calibration  Disconnect the headphones.  Remove any obstacles between the calibration microphone and the speakers.  Auto Calibration is not available when [Bluetooth Mode] is set to [Transmitter].  For accurate measurement, make sure the environment is quiet and free from noise.  Set the speaker output to a setting other than "SPK OFF". See "Selecting the front speakers" (page 36).  Confirm the active subwoofer setup  When a subwoofer is connected, turn on the subwoofer and turn up the volume prior to activating the subwoofer. Turn the LEVEL to just before the mid-point.  If you connect a subwoofer with a crossover frequency function, set the value to maximum.  If you connect a subwoofer with an auto standby function, set it to off (deactivated). Note Depending on the characteristics of the subwoofer you are using, the setup distance value may be different from the actual position. Calibration microphone Note  The speakers emit very loud sound during the calibration and the volume cannot be adjusted. Be considerate of your neighbors and any children who are present.  If the muting function has been activated before you perform Auto Calibration, the muting function will shut off automatically.  It may not be possible to take the correct measurements or to perform Auto Calibration at all if special speakers such as dipole speakers are used.  If the measurement fails, follow the message, then select [Retry]. For details on the error code and warning message, see "List of messages after Auto Calibration measurements" (page 49). To cancel Auto Calibration The Auto Calibration function will be canceled when you perform the following during the measurement process:  Press  (power).  Press the input buttons on the remote control or turn the INPUT SELECTOR on the receiver.  Press .  Press SPEAKERS on the receiver.  Change the volume level.  Connect the headphones. 35GB