Sony STR-DN1070 Operating Instructions - Page 48

The home menu does not appear on the TV screen.  The home menu can only be used when you connect the TV to the HDMI OUT jack.  When you connect the TV to HDMI OUT B/ HDMI ZONE jack, be sure to set [HDMI Out B Mode] to [Main] in [HDMI Settings].  Press HOME to display the home menu.  Check that the TV is connected correctly.  The home menu may take some time to appear on the TV screen depending on the TV. Audio No sound or only a very low level of sound is heard, no matter which device is selected.  Check that all connecting cables are inserted to their input/output jacks on the receiver, speakers and the devices.  Check that the receiver and all devices are turned on.  Check that MASTER VOLUME on the receiver is not set to "VOL MIN".  Check that SPEAKERS on the receiver is not set to "SPK OFF" (page 36).  Check that headphones are not connected to the receiver.  Press  to cancel the muting function.  Try pressing the input button on the remote control or turning INPUT SELECTOR on the receiver to select the device of your choice.  If you want to listen to sound from the TV speaker, set [Audio Out] to [TV + AMP] in the [HDMI Settings] menu. If you cannot play multi-channel audio source, set [AMP]. However, the sound will not be output through the TV speaker.  Sound may be interrupted when the sampling frequency, number of channels or audio format of audio output signals from the playback device is switched.  If you are listening with BLUETOOTH headphones, check that the [Bluetooth Mode] is not set to [Receiver] or [Off].  No sound is output from the center speaker if you set the speaker pattern to a setting that does not have center speaker and playback a DSD multi-channel source.  No sound is output from the surround speakers if you set the speaker pattern to a 48GB setting that does not have surround speakers and playback a DSD multi-channel source.  No sound is output from the Zone 2/3 speakers if you turn on DSD Native function and play back a DSD file in Main Zone. There is no sound from the TV via the HDMI OUT A (TV) (ARC) jack when using the Audio Return Channel function.  Set [Control for HDMI] to [On] in the [HDMI Settings] menu.  Make sure that your TV is compatible with the Audio Return Channel function.  Make sure that the HDMI cable is connected to a jack on your TV that is compatible with the Audio Return Channel function. The surround effect cannot be obtained.  Make sure you have selected a sound field for movies or music.  "PLll Movie", "PLll Music", "PLllx Movie", "PLllx Music", "Neo6.CINEMA", and "Neo6.MUSIC" do not work when the speaker pattern is set to "2.0" or "2.1". Network connection Cannot connect to the network using WPS via a wireless LAN connection.  You cannot connect to a network using WPS if your access point is set to WEP. Set up your network after searching the access point using the access point scan. Cannot connect to the network.  Check that the LAN cable is connected to the receiver when you want to connect the receiver to the network via a wired LAN connection.  Check the network information. If the connection failed, set up the network connection again.  If the receiver is connected through a wireless network, move the receiver and the wireless LAN router/access point closer to each other and perform the setup again.  Make sure that you use a wireless LAN router/access point.  Make sure that the wireless LAN router/ access point is turned on.  Check the settings of the wireless LAN router/access point and perform the