Sony STR-DN1080 Operating Instructions - Page 40
Setting up the Receiver using the Easy Setup, Before you perform Auto, Calibration
View all Sony STR-DN1080 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Setting up the Receiver using the Easy Setup To perform initial setup of the receiver, make sure a TV is connected to the receiver (page 29). Then, switch the input of the TV to the input to which the receiver is connected. Note It is not possible to perform the Easy Setup procedure using the indications on the front display panel. When you turn on the receiver for the first time or after the receiver is initialized, the Easy Setup screen appears on the TV screen. Follow the on-screen instructions to make the basic settings using / / / and . Easy Setup Welcome! Select your language. English Español Français Deutsch : Choose : Go back : Continue : Apply the selection If the Easy Setup screen does not appear or you want to display the Easy Setup screen manually, you can display it by pressing HOME, then select [Setup] - [Easy Setup]. Setup Easy Setup Restarts Easy Setup to configure basic settings. Follow the on-screen instructions. Speaker Settings Audio Settings HDMI Settings Input Settings Network Settings Bluetooth Settings Zone Settings Select BACK Back What you can do with Easy Setup By performing Easy Setup, you can complete: 1: Language selection 2: Speaker settings Check your speaker system and perform Auto Calibration according to the configuration and arrangement of your speaker system. 3: Internet settings Select the network connection method and configure settings to connect the receiver to the network. Performing Auto Calibration (D.C.A.C. EX) Before you perform Auto Calibration Disconnect the headphones. Remove any obstacles between the calibration microphone and the speakers. Auto Calibration is not available when [Bluetooth Mode] is set to [Transmitter]. For accurate measurement, make sure the environment is quiet and free from noise. Set the speaker output to a setting other than "SPK OFF." See "Selecting the front speakers" (page 41). Confirm the active subwoofer setup Before using a subwoofer, turn on the subwoofer and turn up the volume. Turn the LEVEL to just before the mid-point. When a subwoofer with a crossover frequency function is connected, set the value to maximum. When a subwoofer with an auto standby function is connected, set it to off (deactivated). 40GB Note Depending on the characteristics of the subwoofer you are using, the setup distance value may be different from the actual position.