Sony STR-DN1080 Operating Instructions - Page 57
Error messages, List of messages after Auto, Calibration measurements
View all Sony STR-DN1080 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Additional Information Cannot select the [Network Settings] menu. Wait for a few moments after you have turned on the receiver, and then select the [Network Settings] menu again. Error messages "PROTECTOR" appears on the display panel. The receiver will automatically turn off after a few seconds. Check the followings: There may be an electrical surge or power failure. Unplug the AC power cord (mains lead) and then plug in the cord again after 30 minutes. The receiver is covered and the ventilation holes are blocked. Remove the object covering the ventilation holes of the receiver. The impedance of the connected speakers is below the rated impedance range indicated on the back panel of the receiver. Reduce the volume level. Unplug the AC power cord (mains lead) and let the receiver cool down for 30 minutes while performing the following troubleshooting: Disconnect all of the speakers and subwoofer. Check that the speaker wires are tightly twisted on both ends. Connect the front speaker first, increase the volume level and operate the receiver for at least 30 minutes until it completely warms up. Then, connect each additional speaker one by one and test each additional speaker until you detect which speaker is causing the protection error. After checking the above items and fixing any problems, plug in the AC power cord (mains lead) and turn on the receiver. If the problem persists, consult your nearest Sony dealer. [Overload occurred.] appears on the TV screen. An over-current from the (USB) port was detected. Disconnect the USB device as prompted in the warning message and close the message. List of messages after Auto Calibration measurements Code 30 Headphones are connected. Please disconnect the headphones and retry calibration. Code 31 The front speakers are not selected correctly. Select the front speakers correctly using SPEAKERS on the receiver and perform Auto Calibration again while sound is being output. For details on selecting the front speakers, see "Selecting the front speakers" (page 41). Code 32, Code 33 Sound is not detected from one or both of the speakers. Sound is not detected from one or both of the front speakers. Please ensure that the calibration microphone is not damaged, and is connected to the CALIBRATION MIC jack on the front panel of the receiver, and that all speakers are properly connected. Sound is not detected from either the left or right surround speakers. Please ensure that the surround speakers are connected to the SURROUND terminals. The surround back speaker is connected to the SURROUND BACK/HEIGHT R terminal. When using only one surround back speaker, please connect it to the SURROUND BACK/HEIGHT L terminals. Only one height speaker is detected. Please ensure that both the height speakers are connected to the SURROUND BACK/HEIGHT terminals. Sound is not detected from any speakers, please ensure the calibration microphone is not damaged and is connected to the CALIBRATION MIC jack on the front panel of the receiver. Code 34 Speakers are not placed in the proper position or the calibration microphone may be reversed. 57GB