Stihl FS 80 Instruction Manual - Page 26
Loop handle without barrier bar, Securing the loop handle
View all Stihl FS 80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
English / USA 002BA099 KN 002BA136 KN 002BA147 KN 4 2 3 5 6 7 8 8 7 74 3 5 6 1 1 A 9 4 10 : Place the clamp (3) in the loop handle (4) and position them both against the drive tube (5). : Fit the clamp (6) and place the barrier bar (2) in position. Note correct position. : Line up the holes. : Insert screws (7) in holes and screw them into the barrier bar as far as stop. : Go to "Securing the loop handle". Loop handle without barrier bar : Place the clamp (3) in the loop handle (4) and position them both against the drive tube (5). : Fit the clamp (6) and line up the holes. : Fit washers (7) on screws (8). : Insert screws (8) in holes and screw on the square nuts (1) as far as stop. : Go to "Securing the loop handle". Securing the loop handle : Secure the loop handle (4) approx. 8"/20cm (A) forward of the control handle (9). : Line up the loop handle. : Tighten down the screws firmly - lock the nuts if necessary. 10= Sleeve* FS 80, FS 80 R, FS 85, FS 85 R * see "Guide to Using this Manual" 25