Stihl FS 80 Instruction Manual - Page 29
Removing Mounting Hardware, Blocking the Output Shaft
View all Stihl FS 80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
English / USA Mounting hardware is packed with the machine Mowing heads and metal cutting tools may be mounted. The rider plate (4) is in the parts kit supplied with the machine. : Go to "Mounting the Mowing Head" or "Mounting Metal Cutting Tools". Mounting hardware is loose : Pull the hose (1) (protector for shipping) off the shaft (2). The nut (3), rider plate (4) and thrust washer (5) are in the parts kit supplied with the machine. : Go to "Mounting the Mowing Head" or "Mounting Metal Cutting Tools". Blocking the Output Shaft 2 8 7 7 002BA166 KN Mounting hardware is secured to gearhead : Go to "Removing Mounting Hardware" Removing Mounting Hardware : Block the shaft - see next section on "Blocking the Output Shaft". : Use the combination wrench (6) (supplied with machine or available as special accessory) to unscrew the nut (3) clockwise (left-hand thread) from the shaft (2). : Pull the thrust washer (5) off the shaft (2). : Insert the stop pin or screwdriver (7) (supplied with machine or available as special accessories) in the hole (8) in the gearhead as far as stop - apply slight pressure. : Rotate nut or cutting tool on the shaft (2) until the stop pin slips into position and blocks the shaft. 28 FS 80, FS 80 R, FS 85, FS 85 R