Stihl FS 80 Instruction Manual - Page 31
Replacing Nylon Line or Cutting, Blades, Mounting Metal Cutting Tools
View all Stihl FS 80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
English / USA STIHL AutoCut : Hold the rotating mowing head above the ground - tap it on the ground once - about 1 1/4" (3 cm) fresh line is advanced. The blade on the deflector trims overlong line to the correct length - avoid tapping head more than once at a time. Line feed operates only if both lines still have a minimum length of 1" (2.5 cm). All other mowing heads Refer to the instructions supplied with the mowing head. To reduce the risk of injury, always shut off the engine before adjusting the nylon line by hand. Replacing Nylon Line or Cutting Blades Refer to the instructions supplied with the mowing head. Mounting Metal Cutting Tools Remove the skirt and blade from the mowing head deflector before mounting grass cutting blade 230-4 (1), grass cutting blade 230-8 (2), or brush knife (3) - see "Mounting the Deflector" Fit the appropriate limit stop before mounting the circular saw blade 200 (4,5) - see "Mounting the Deflector". : Lay your machine on its back with the gearhead facing upward. Cutting edges of (1) and (3) may point in either direction. Cutting edges of (2), (4) and (5) must point clockwise. Direction of rotation is marked by arrow on inside of cutting head deflector or limit stop. 30 FS 80, FS 80 R, FS 85, FS 85 R