Stihl FS 88 Instruction Manual - Page 26
Mounting the Cutting Tools
View all Stihl FS 88 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Mounting the Cutting Tools [\ 1t f6\ \ 8 • Lay your brushcutter on its back with the gear head facing up. Blocking the output shaft • Insert stop pin (1) in the bore (2) at the side of the gear head as far as stop - apply slight pressure. • Rotate output shaft until the stop pin slips into position and blocks the shaft. Removing cutting tool mounting hardware • Position combination wrench (3) on the mounting nut (4). • Release and unscrew the nut clockwise (left-hand thread). • Remove shipping keeper (5) if fitted. • Pull the rider plate (6) and thrust washer (7) off the shaft (8). • Now fit the cutting tool. 25
Mounting the Cutting Tools
8
6
\
f
\
\
1
t
[
•
Lay your brushcutter on its back
with the gear head facing up.
Blocking the output shaft
•
Insert stop pin
(1)
in the bore
(2)
at
the side of the gear head as far as
stop - apply slight pressure.
•
Rotate output shaft until the stop
pin slips into position and blocks the
shaft.
Removing cutting tool mounting
hardware
•
Position combination wrench
(3)
on the mounting nut (4).
•
Release and unscrew the nut
clockwise (left-hand thread).
•
Remove shipping keeper
(5)
-
if fitted.
•
Pull the rider plate
(6)
and
thrust washer
(7)
off
the shaft (8).
•
Now fit the cutting tool.
25