Stihl HT 75 Instruction Manual - Page 29
Taking Care of Guide Bar, Cleaning the Air Filter, Turn the bar over, Measure groove depth
View all Stihl HT 75 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
english Taking Care of Guide Bar Cleaning the Air Filter : Measure groove depth - with scale on filing gauge - see "Special Accessories" - in area 2 used most for cutting on Rollomatic bars. Chain type Picco-Mini Chain pitch Minimum groove depth 3/8" P 5.0 mm (0.20") 1 3 : Turn the bar over - every time you sharpen the chain - and every time you replace the chain - this avoids one-sided wear, especiallly at nose and underside of the bar. Regularly clean 1 = oil inlet hole 2 = oil passage 3 = bar groove If groove depth is less than specified: : Replace the guide bar. The drive link tangs will otherwise scrape along the bottom of the groove - the cutters and tie straps will not ride on the rails. 2 1 Dirty air filters reduce engine power increase fuel consumption and make starting more difficult. If there is a noticeable loss of engine power : Move choke lever to g. : Press in the tab (1). : Ease the filter cover (2) over the tab and take it away. : Clean away loose dirt from around the filter. : Remove the foam and felt filter elements. 390BA050 KN 355BA014 KN 28 HT 70, HT 75