Stihl MS 192 C-E Product Instruction Manual - Page 34

English STOP 1 3 2 N Press down the throttle trigger lockout (1) and squeeze the throttle trigger (2) at the same time - hold both levers in that position. N Move the Master Control lever (3) to n and hold it there. N Now release the throttle trigger, Master Control and throttle trigger lockout in that order. This is the starting throttle position. if the engine is cold 151BA008 KN If the engine is warm 4 N Set the choke lever (4) to j . Also use this position if the engine has been running but is still cold. 151BA010 KN N Hold the saw firmly on the ground with your left hand on the front handle - your thumb should be under the handle. N Put your right foot into the rear handle and press down. 151BA012 KN 4 N Move the choke lever (4) to l. 32 151BA009 KN N Place your saw on the ground. Make sure you have a firm footing - check that the chain is not touching any object or the ground. Bystanders must be well clear of the general work area of the saw. 161BA011 KN Alternative method of starting: N Hold the rear handle tightly between your legs, just above the knees. N Hold the front handle firmly with your left hand - your thumb should be under the handle. N Pull the starter grip slowly and steadily with your right hand and push down the front handle at the same time. Do not pull out the starter rope all the way - it might otherwise break. N Do not let the starter grip snap back. Guide it slowly back into the housing so that the starter rope can rewind properly. MS 192 C