Stihl MS 192 C-E Product Instruction Manual - Page 35
Shut off the engine
View all Stihl MS 192 C-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
When the engine begins to fire. English If the engine does not start 4 If the engine is cold: N Set the choke lever (4) to j and continue cranking until the engine runs. If the engine is warm N Continue cranking until the engine runs. As soon as the engine runs STOP 3 2 N Blip the throttle trigger (2) the Master Control lever (3) moves to the run position F and the engine settles down to idling speed. As the chain brake is still engaged, the engine must be returned to idling speed immediately or the engine housing and chain brake might otherwise be damaged. 151BA013 KN 151BA010 KN N Pull the hand guard back toward the handlebar. The chain brake is now disengaged - your saw is ready for operation. Always disengage chain brake before accelerating the engine. High revs with the chain brake engaged (chain locked) will quickly damage the powerhead and chain drive (clutch, chain brake). N Always check operation of chain lubrication before starting work. At very low outside temperatures N Allow engine to warm up at part throttle. Shut off the engine STOP N Move the Master Control lever to 0 or STOP. 151BA014 KN 151BA005 KN If fuel tank has been run completely dry and then refueled N After refueling, press the fuel pump bulb at least five times - even if the bulb is filled with fuel. Engine is flooded If you did not move the choke lever to warm start j quickly enough after the engine began to fire, the combustion chamber is flooded. N Move the Master Control lever to 0 or STOP. 4 N Insert a suitable tool in the spark plug boot (4). N Pry off the spark plug boot. N Unscrew and dry off the spark plug. N Open the throttle wide. N Set the choke lever to j. N Crank the engine several times with the starter to clear the combustion chamber. N Install the spark plug and connect the spark plug boot, press it down firmly - reassemble the other parts. N Set the Master Control lever to n - the starting throttle position. 151BA015 KN MS 192 C 33