Stihl MS 192 C-E Product Instruction Manual - Page 42
Replacing the starter rope
View all Stihl MS 192 C-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
English Replacing the starter rope N Use a screwdriver to pry the rope out of the starter grip. N Remove the remaining rope from the rotor and starter grip. N The spring under the carrier must engage the rope rotor and the 5 carrier (arrows). 217BA048 KN 151BA021 KN 217BA046 KN 217BA045 KN N Thread the new rope through the starter grip and tie one of the special knots shown. N Pull the knot back into the grip. N Thread the rope through the top of the guide bushing (5). N Thread the rope through the rotor and secure it with a simple overhand knot. 7 4 4 N Fit the pawls (4) in the rotor and fit the washer (3) on the starter post. N Use a screwdriver or suitable pliers to install the spring clip (2) on the starter post and engage it on the pawls' pegs - the spring clip must point clockwise as shown in the illustration. 217BA047 KN N Coat rope rotor bearing bore with non-resinous oil. N Slip the rotor (6) with carrier (7) over the starter post - turn it back and forth to engage the anchor loop of the rewind spring. 40 MS 192 C