Symphonic CSTL20D6 Owner's Manual - Page 32

TROUBLESHOOTING GUIDE If the unit does not perform properly when operated as instructed in this Owner's Manual, check the unit, consulting the following checklist. PROBLEM No power No operation by infrared remote control CORRECTIVE ACTION • Make sure the power plug is connected to an AC outlet. • Make sure the power is turned on. • Check if the power plug is connected to an AC outlet. • Check the batteries in the remote control. • Aim the remote control directly at the remote sensor. If necessary, remove all the obstacles between the sensor and the remote control. • Refer to "IR SIGNAL CHECK" on page 34. • You have to be within 23 feet (7m) of the unit. • Check if the correct mode is selected. If not, switch the mode by pressing [SELECT], whichever you need. TV Mode Sometimes a performance problem can be easily solved by checking seemingly apparent but often overlooked possibilities. Before arranging for service, check these items. It could save your time and money. PROBLEM No picture or sound No picture or poor picture on the unit No sound or poor sound Bars on screen Picture distorted or blurred Picture rolls vertically Lines or streaks in picture No color Poor reception on some channels Ghosts in picture Weak picture CORRECTIVE ACTION • Make sure the AC cord is connected to an AC outlet. • Check antenna connection. • Press [SELECT] to select TV mode. Then try other TV feature. • Let the unit program its tuner memory. • Adjust direction or replace antenna. • Adjust picture controls. • Check for broken pin of the antenna cable. • Adjust volume control on remote control or main unit. • Press [MUTE] to restore sound. • If outside antenna is being used, check for broken wire. • Check for local interference. • Try a new channel, if OK, then possible station trouble. • If outside antenna is being used, check for broken wire. • Try a new channel, if OK, then possible station trouble. • If outside antenna is being used, check for broken wire. • Check for local interference. • Try a new channel, if OK, then possible station trouble. • Check the antenna or cable connection to the main unit. • If outside antenna is being used, check for broken wire. • Adjust "COLOR" control. • Try a new channel, if OK, then possible station trouble. • Check the antenna or cable connection to the main unit. • If outside antenna is being used, check for broken wire. • Check for local interference. • Try a new channel, if OK, then possible station trouble. • Check the antenna or cable connection to the main unit. • If outside antenna is being used, check for broken wire. • Adjust "CONTRAST" & "BRIGHTNESS" control. EN - 32 -