Symphonic CSTL20D6 Owner's Manual - Page 9

PREPARATION FOR USE ANTENNA/CABLE CONNECTION NOTE • Cables used here are commercially available. • For your safety and to avoid damages to the unit, unplug the antenna cable from the ANT jack before moving the unit. - ANTENNA/CABLE CONNECTION [Rear of this unit] from Cable TV signal or Antenna DA(CIUGODIATIOXAILOALU)T VIDEO2 R ACUPDMIOPOLYNENT Pb Pr R AUDIO L VIDEO1 VIDEO S-VIDEO ANT HEAD PHONE RF Cable ANT IF YOU HAVE A JACK ON THE WALL Connect the TV to the wall-mounted antenna jack with an RF cable (commercially available). IF YOU HAVE A WIRED CABLE Connect the TV to the wired antenna cable. NOTE • Before plugging the antenna into the ANT jack of the unit, check that the pin is not bent. If it is bent, straighten the pin as illustrated, then plug the pin into the ANT jack of the unit. Bent pin Cable Plug (Needs to be straightened) (Straight pin) - CABLE/SATELLITE BOX CONNECTION [Rear of this unit] WHEN USING CABLE BOX/SATELLITE BOX (DACIUGODIATIOXAILAOLU)T VIDEO2 R ACUPDMIOPOLYNENT Pb Pr Cable Box or Satellite Box If your cable service supplies you with a converter box or if you use a satellite system, you can use the basic connection as illustrated. Channel selection must be made with the converter box or satellite box. This means that channels cannot be changed using the remote control of this unit. R AUDIO L VIDEO1 VIDEO S-VIDEO ANT HEAD PHONE ANT OUT IN 75-ohm Coaxial Cable from Cable Company or Satellite dish NOTE Note to CATV system installer: • This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical. -9- EN