TASCAM CD-200BT Owners Manual - Page 18

4 - CD playback Playback area With data CDs, you can set the area to be used for playback (PLAY AREA setting). Follow the procedures below to set the playback area. Setting the playback area Press and hold the PLAY MODE/PLAY AREA [SOURCE SEL] button on the main unit or press the remote control PLAY AREA button to set the playback area. The selected playback area is shown as follows in the main display area for about two seconds and then disappears. Depending on the selected playback area, the FOLDER indicator might also appear on the display. Main FOLDER display area indicator Meaning ALL PLAY Not shown All files on the data CD will be played back. FOLDER Shown All files in the selected folder on the data CD will be played back. Playback modes This unit can play back tracks using the following four playback modes. Continuous playback mode (default setting) Tracks on the CD are played back in numerical order. NOTE When FOLDER is the playback area for a data CD, the tracks in the current folder will be played back in numerical order. Single playback mode The selected track on the CD is played back once and then playback stops. Random playback mode The tracks on the CD are played back in random order regardless of their track numbers. Playback stops after all tracks have been played. NOTE When FOLDER is the playback area for a data CD, the tracks in the current folder will be played back in random order. (See "Folder playback (data CDs)" on page 20.) Program playback mode The programmed tracks are played back in program order. See "Programmed playback" on page 20 for details. Selecting the playback mode Press the main unit PLAY MODE/PLAY AREA [SOURCE SEL] button or the remote PLAY MODE button to cycle through the playback modes. During playback, however, you can only switch among continuous, single and random playback modes. To select programmed playback, press the main unit PLAY MODE/PLAY AREA [SOURCE SEL] button or the remote PLAY MODE button when playback is stopped. The currently selected playback mode is shown on the display as follows. Indicator No indicator SNGL RAND PROG Playback mode Continuous playback mode Single playback mode Random playback mode Program playback mode The selected playback mode is retained even when the power is turned off. NOTE Immediately after pressing the PLAY MODE/PLAY AREA [SOURCE SEL] button on the main unit or the PLAY MODE button on the remote control, the selected mode is shown on the main display area as follows. Continuous playback mode set: CONTINUE Single playback mode set: SINGLE Random playback mode set: RANDOM Programmed playback mode set: PROGRAM 18 TASCAM CD-200BT