TP-Link T2500G-10MPS T2500G-10MPSUN V1 CLI Reference Guide Guide - Page 199

Parameter ip -- The type of the IP address for tracert test should be IPv4. ipv6 -- The type of the IP address for tracert test should be IPv6. ip_addr -- The IP address of the destination device. If the parameter ip/ipv6 is not selected, both IPv4 and IPv6 addresses are supported, for example 192.168.0.100 or fe80::1234. maxHops -- The maximum number of the route hops the test data can pass though. It ranges from 1 to 30. By default, this value is 4. Command Mode User EXEC Mode and Privileged EXEC Mode Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. Example Test the connectivity between the switch and the network device with the IP 192.168.0.131. If the destination device has not been found after 20 maxHops, the connection between the switch and the destination device is failed to establish: T2500G-10MPS# tracert 192.168.0.131 20 Test the connectivity between the switch and the network device with the IP fe80::1234. If the destination device has not been found after 20 maxHops, the connection between the switch and the destination device is failed to establish: T2500G-10MPS# tracert fe80::1234 20 21.29 show system-info Description The show system-info command is used to display System Description, System Name, System Location, Contact Information, Hardware Version, Software Version, Bootloader Version, Mac Address, System Time, Run Time and so on. Syntax show system-info 181