TP-Link TL-SG3424P TL-SG3424P V1 CLI Guide - Page 163
MSTP Commands, spanning-tree global
View all TP-Link TL-SG3424P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 163 highlights
Chapter 26 MSTP Commands MSTP (Multiple Spanning Tree Protocol), compatible with both STP and RSTP and subject to IEEE 802.1s, can disbranch a ring network. STP is to block redundant links and backup links as well as optimize paths. spanning-tree global Description The spanning-tree global command is used to configure STP globally. To return to the default configuration, please use no spanning-tree global command. Syntax spanning-tree global [status { disable | enable }] [mode { stp | rstp | mstp }] [cist cist] [htime hello-time] [mage max-age] [delay forward-delay] [hcount hold-count] [mhop max-hops] no spanning-tree global Parameter status -- Enable/ Disable STP function globally. By default, it is disabled. mode -- STP Version. There are three options, including STP (Spanning Tree Protocol), RSTP (Rapid Spanning Tree Protocol) and MSTP (Multiple Spanning Tree Protocol). By default, the STP version is STP. cist -- CIST Priority, which must be multiple of 4096 ranging from 0 to 61440. By default, the CIST priority is 32768. CIST Priority is an important criterion on determining the root bridge. In the same condition, the switch with the highest priority will be chosen as the root bridge. The lower value has the higher priority. hello-time -- Hello Time, which is the interval to send BPDU packets, and used to test the links. Hello Time ranges from 1 to10 in seconds and it is 2 by default. Otherwise, 2 * (Hello Time + 1) = Max Age. 150