TP-Link TL-SG3424P TL-SG3424P V1 CLI Guide - Page 207
lldp tlv-select, lldp med-status
View all TP-Link TL-SG3424P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 207 highlights
lldp tlv-select Description The lldp tlv-select command is used to configure TLVs to be included in outgoing LLDPDU. To exclude TLVs, please use no lldp tlv-select command. By default, All TLVs are included in outgoing LLDPDU. Syntax lldp tlv-select [port-description] [system-capability] [system-description] [system-name] [management-address] [port-vlan-id] [protocol-vlan-id] [vlan-name] [link-aggregation] [mac-phy] [max-frame-size] [power] [all] no lldp tlv-select [port-description] [system-capability] [system-description] [system-name] [management-address] [port-vlan-id] [protocol-vlan-id] [vlan-name] [link-aggregation] [mac-phy] [max-frame-size] [power] [all] Command Mode Interface Configuration Mode(interface ethernet / interface range ethernet) Example Exclude "management-address" and "port-vlan-id" TLVs in LLDPDU outgoing from port 8: TP-LINK(config)# interface ethernet 8 TP-LINK(config-if)# no lldp tlv-select management-address port-vlan-id lldp med-status Description The lldp med-status command is used to enable the port's LLDP-MED status. Enable the port's LLDP-MED status, and the port's Admin Status will be changed to Tx&Rx. To disable LLDP-MED status, please use no lldp med-status command. Syntax lldp med-status {enable } no lldp med-status Parameter enable -- Enable the port's LLDP-MED status, and the port's Admin Status will be changed to Tx&Rx. Command Mode 194