Thermador ME301YP Installation Instructions - Page 12

en-us Installing the ovens into the cabinet 4. CAUTION - Risk of injury! Follow the instruc- tions below to prevent the latch from slamming shut and pinching or cutting your hand. Close the oven door until it catches on the hinge stop levers, locking the hinges at the proper angle for door removal. a The door will be open about 7" (18 cm) at the top. 5. CAUTION - Risk of injury! The door is heavy. ▶Do not grip the door by the handle. ▶Use both hands to firmly grip it by the sides. Maintaining the door angle, lift the door straight up approximately 3/4" (2 cm) to unhook the hinges from the slots and then pull it out towards you until the hinges are clear of the oven housing. 6. Place the door in a convenient and stable location. Do not lay the door on its handle. This could cause dents or scratches. Installing the ovens into the cabinet Installing the ovens into the cabinet Follow these instructions to install your appliance in the Installingtheovensintothecabinet cabinet. CAUTION Risk of injury! It is recommended to wear protective clothing during the lifting process. ▶ Wear gloves and long sleeves to protect hands and forearms from abrasion and potential scratches. ▶ Take off watches and jewelry. ▶ Wear work shoes for foot protection. CAUTION Risk of crushing! ¡ DO NOT attempt to lift the unit by holding the oven's upper heating element. ¡ Three people or proper equipment are needed to safely lift the combination oven into the cabinet opening. Requirements ¡ You have verified the cabinet dimensions and electri- cal connections. ¡ You have removed the oven door. → "Removing the oven door from bottom hinge conventional ovens", Page 11 ¡ "You have read the lifting recommendations" → Page 10. 1. Position the unit on its packaging base close to and in front of the cabinet opening. 2. Lift or slide the unit into the cabinet cutout. Do not allow the unit base to contact the flooring. 3. Guide the unit straight back into the cabinet cutout. Push the unit straight in until the oven trim is about 2" (5 cm) from being flush with cabinet wall. 4. Check that the electrical conduit cable is not crimped between the oven and the cabinet back wall. If necessary, guide the electric conduit cable into the wall of the cabinet access hole so it does not prevent the unit from being pushed all the way into the cabinet opening. 5. Check that the oven is straight and level. 6. Push the unit all the way back into the cabinet cutout until the front edge of the unit is flush with the front of the cabinet. 7. Install the supplied screws through the tap holes in the trim. Refer to the enclosed SCREW INSTALLATION leaflet. Reinstalling the oven door 1. Hold the door firmly in both hands. Grip it on either side, not by the handle. 2. Tilt the door back slightly towards you until it opens about 7" (18 cm) at the top. 12