Thermador SGSX365TS Instructions for Use - Page 12
Thermador ExtraLow, XLO STAR™, Burners SGSX and SGSXP models only, Burner ON Lights, Install
View all Thermador SGSX365TS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Checking Burner Cap Placement ▯ Check to make sure that there is no gap between the burner cap and burner base. See illustration below for correct and incorrect placements of the burner cap. ▯ You may gently try to move the burner cap from side to side to check if it is properly placed. If properly placed, the cap will click from side to side as the prongs hit the groove ridge. Burner "ON" Lights For SGS and SGSX models: There is an "ON" light on this cooktop. When illuminated, it indicates at least one burner is in use. For SGSP models: An "ON" light corresponds with the knob for each burner (a total of five lights). When illuminated, it indicates that the corresponding burner is in use. For SGSXP models: A light ring around each knob will illuminate to indicate that the corresponding burner is in use. Install Burner Grates Properly position and install each burner grate according to each individual model as shown in the illustrations below. 30" SGS Thermador ExtraLow® (XLO) STAR™ Burners (SGSX and SGSXP models only) The center and left front burners are enhanced with the ExtraLow® (XLO®) feature. XLO allows the reduction of heat even further than the Low setting in order to simmer, poach, melt or hold cooked food without scorching or burning. The XLO feature has the following properties: 30" SGSP ▯ The XLO feature will cycle the burner flame ON and OFF when the control knob is set within one of the five XLO settings (the time the flame is ON depends on the knob setting). ▯ Igniters will spark during the re-ignition of the XLO burners. There will be a slight clicking noise when this occurs (approximately every 60 seconds). ▯ For SGSXP models only, the left side of the light ring will turn off and the right side of the light ring will illuminate in blue when activating the XLO setting. 9 WARNING Do not clean or touch any of the burners when one or both ExtraLow® burners are in use. When the ExtraLow® burner automatically reignites, the igniter at the burner will spark. 36" SGSX 12