Vtech CS6129-41 User Manual - Page 7
Battery installation and charging - handset
UPC - 735078016478
View all Vtech CS6129-41 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Getting started Battery installation and charging Install the battery as shown below. After installing the battery, you might be able to make and receive short calls. For best performance, charge the handset for at least 16 hours before use. When the battery power is low, the handset will beep, display LOW BATTERY and will flash on the handset screen. Place the handset in the telephone base or charger to charge the battery when not in use. See the table on page 53 for battery operating times. If the battery is depleted, it may take approximately four minutes to charge the handset before it can resume screen display. The screen will continue to display LOW BATTERY until the battery has been charged for approximately one hour. Charge light 1 Plug the battery securely into the plug inside the handset battery compartment, matching the colorcoded label. 2 3 4 Place the battery with Align the cover flat Charge the handset the label THIS SIDE against the battery by placing it in the UP facing up and the compartment, then telephone base wires inside the battery slide it upwards until it or charger. The compartment. Route clicks into place. CHARGE light will be the wires through the on when the handset slot at the bottom of the is charging. battery compartment. www.vtechphones.com • If the handset will not be used for a long time, disconnect and remove the battery to prevent possible leakage. • To purchase replacement batteries, visit our website at www. vtechphones. com or call 1 (800) 595-9511. In Canada, go to www.vtechcanada. com or call 1 (800) 267-7377. Basic operation Getting started