Weider Wedier Pro 9635 Canadian English Manual - Page 10
Arm Assembly
View all Weider Wedier Pro 9635 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
ARM ASSEMBLY 12. Attach the Press Arm (46) to one side of the 12 Press Frame (17) with two M8 x 63mm Bolts (22) and two M8 Nylon Locknuts (3). Assemble the other Press Arm (46) in the same manner. 46 22 46 13. Identify the Right Arm (48) and the Left Arm (47). Note the position of the welded bracket on each Arm. Arm identification is very important for step 14. Attach a "V"-pulley (50) and a Long Cable Trap (31) to the Right Arm (48) with an M10 x 57mm Bolt (86) and an M10 Nylon Locknut (21). Do not tighten the Locknut yet. Attach a "V"-pulley (50) and a Long Cable Trap (31) to the Left Arm (47) in the same manner. 13 86 31 50 Welded Brackets 48 3 17 31 50 47 21 14. Lubricate both axles on the Top Frame (55). 14 Slide the Right Arm (48) onto the right axle. Note: Be careful not to confuse the Right Arm with the Left Arm (47); refer to step 13 to identify the Right Arm. Make sure that the upper end of the Right Arm is behind the indicated bracket on the Top Frame (55). Tap two 25mm Retainers (69) and a 25mm 48 Round Cover Cap (70) onto the axle. Make sure that the teeth on the Retainers bend toward the Round Cover Cap, as shown in the inset drawing. Attach the Left Arm (47) in the same way. Wet the lower end of the Right and Left Arms (47, 48) with soapy water. Slide a 254mm Pad (45) onto the lower end of each Arm. 45 55 Bracket 47 Lubricate Axle 69 45 70 Axle 69 70 10