Weider Wedier Pro 9635 Canadian English Manual - Page 12

18. Wrap the High Cable (58) around a "V"-pulley 18 (50). Attach the "V"-pulley and a Long Cable Trap (31) to the indicated bracket on the Front Upright (42) with an M10 x 57mm Bolt (86) and an M10 Nylon Locknut (21). Make sure that the Long Cable Trap is positioned to hold the Cable in place. 19. Route the High Cable (58) around the "V"-pulley (50) on the Left Arm (47). Make sure that 19 the Cable is in the groove of the Pulley and that the Long Cable Trap (31) is posi- tioned to hold the Cable in place. Tighten the M10 x 57mm Bolt (86) and the M10 Nylon Locknut (not shown). 86 31 58 50 Bracket 42 21 50 86 31 58 47 20. Route the High Cable (58) around the "V"-pul- 20 ley (50) on the Right Arm (48). Make sure that the Cable is in the groove of the "V"- pulley and that the Long Cable Trap (31) is turned to hold the Cable in place. Tighten the M10 x 57mm Bolt (86) and the M10 Nylon Locknut (not shown). 58 31 86 50 48 CABLE ASSEMBLY 21. Attach the Pulley Bracket (20) to the Top 21 Frame (55) with the M8 x 120mm Bolt (68) and an M8 Nylon Locknut (3). Do not over- 68 tighten the Locknut; the Pulley Bracket must be able to move freely. See the inset drawing. Route the High Cable 55 (58) over the 90mm Pulley (15) attached to the Pulley Bracket (20). Tighten the M10 x 20 47mm Bolt (not shown) and an M10 Nylon 3 Locknut (21). Make sure that the Cable is in the groove of the Pulley and that the Cable Trap (66) is turned to hold the Cable in place. 66 21 15 58 12