Xerox 850DX Xerox Wide Format 8825/8830/8850/8855/X2 Tech System Introduction - Page 23

Quick Start for Document Copying NOTE: Copying is not currently supported by the X2-TECH system. • Make sure that media is loaded into all drawers of the XES Synergix 8825, 8830, 8850, or 8855 Printer. For full details on loading the roll media, go to the 8825/8830/8850 or 8855 Printer Operator Manual. • 8825/8830/8850 Digital Solution: If necessary, power on the Scanner/Controller Circuit Breaker/Printer. (The Scanner MUST be powered on first to be recognized.) • 8855 Digital Solution: If necessary, power on the Scanner/Controller/Printer. The Scanner MUST be powered on first to be recognized.) • After initial power up, if the Scanner Control Panel prompts you for your User ID and Account ID, enter the alphanumeric Identifications supplied to you by your System Administrator. • If your system was already powered up, you may have to press the Mode key to display "Ready To Copy." When the Scanner Control Panel displays "Ready To Copy," press the C/CA key on the Control Panel's keypad to be certain that all settings are at their factory default values. Note: To modify settings, refer to the XES Synergix & X2-TECH Digital Solution User Guide. • Insert your original document face down and centered on the feed tray of the Scanner. • Gently move your document forward until the Scanner's feed rolls engage the document's leading edge. • As your document is automatically fed into the Scanner the resulting image will be sent to the printer and your copy will be automatically printed. XES Synergix 8825/8830/8850/8855 & X2-TECH System Introduction NOTE: You may have to press the Start button if the configuration (for Auto Scan) has been changed from the factory default. For full details on Scanner Configuration, refer to the XES Synergix & X2-TECH Digital Solution User Guide. • When your document is returned to the ready position, lift the Thick Document lever on the far right hand corner of the Scanner to remove your document. NOTE: Your document may be fed out of the rear of the Scanner if the configuration (for Document Return) has been changed from the factory default. For full details on Scanner Configuration, refer to the XES Synergix & X2-TECH Digital Solution User Guide. • If you entered a User ID and Account ID when using the Scanner, be sure to press the Exit key to log out of the system. READY TO COPY INSERT DOCUMENT AUTO 100.0 % Menu Previous Next Enter Exit Mode Batch Transform Sample Sets Build Finisher Store/ Recall Printer Interrupt A D 1 2 B C 3 E F 4 5 6 G J M H I K N L O 7 . P Q R S 8 0 T U V 9 W X Y Z C/CA Stop Start Figure 8. Keys of the Scanner Control Panel 15