Xerox P8EX Spire CXP8000 Color Server - User Guide - Page 330
Slowly insert the Image Start Points Calibration Chart to the X-Rite, Continuous Tone Chart, Magenta
UPC - 095205085853
View all Xerox P8EX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 330 highlights
316 Chapter 7 - Color Workflow 9. Make sure that the green light on the X-Rite DTP32HS is on and blinking. Center the cyan column under the alignment mark on the densitometer. 10. Slowly insert the Image Start Points Calibration Chart to the X-Rite DTP32HS densitometer until it is automatically advanced by the densitometer motor.The green light slowly flashes while the chart is pulled through the densitometer and out the back. A beep sounds and a green light blinks when the scan is complete. A check mark appears over the cyan icon and instructions appear for the next sweep, this time for the magenta column. 11. After each color sweep, wait for the check mark to appear over the appropriate icon and follow the instructions as listed. Note: Ensure that the separation columns on the Continuous Tone Chart are scanned in the order they appear in the icons: Cyan>Magenta>Yellow>Black. When all of the separation columns have been successfully scanned, a check mark appears next to all icons. Notes: • If at any stage the scanning has not been completed properly, click Reset and scan again. • If an error occurs while you are scanning the chart, an alert message appears. Click OK and re-scan the charts.