Yamaha AW4416 Reference Guide - Page 28
Additional functions in the D.in, Setup
View all Yamaha AW4416 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
C FS (sampling frequency) This shows the sampling frequency of the signal that is currently selected as the clock source. If you select an external clock as the clock source, you must check that the sampling frequency of the song matches the frequency of the external clock. For example if you are synchronized to a 48 kHz external clock and record on a 44.1 kHz song, be aware that the pitch will change when you return the clock source setting to "INT" and play back. D VARI (vari-pitch) If "INT" is selected as the clock source, you can select whether the sampling frequency will be fixed (FIX button on) or variable (VARI button on). If "FIX" is selected, the control change frequency of the internal clock will be displayed at the right. If "VARI" is selected, you can move the cursor to the knob at the right and rotate the [DATA/ JOG] dial to make fine adjustments to the sampling frequency over a range of -5.97%- +6.00%. E STEREO BUS CASCADE This selects whether the digital device connected to the DIGITAL STEREO IN jack will be cascaded with the stereo bus of the AW4416. When you move the cursor to the "DISABLE" button and press the [ENTER] key, the button display will change to "ENABLE," and the input signal from the DIGITAL STEREO IN jack will be sent directly to the stereo bus of the AW4416. At this time, you can use the ATT. knob to adjust the level (attenuation) of the input signal. SET UP screen s Additional functions in the D.in Setup page In the D.in Setup page, you can press the [SHIFT] key to assign the following function to the [F1] key. F1 • [F1] (CHANGE TAB) key Switch between the two types of tab display. In order for the device connected to the DIGITAL STEREO IN jack to be cascade-connected to the stereo bus, the clock source must be set to "D.ST IN." If another clock source is selected, a message of "CANNOT ASSIGN DIGITAL-ST-IN." will be displayed, and it will not be possible to set the button to "ENABLE." 21 - Reference Guide