Yamaha AW4416 Reference Guide - Page 98

• On the AW4416, the number of tracks that can be played back simultaneously may be limited according to the quantization (word bit length) of the song and by the number of tracks being recorded simultaneously. In this case, a message of "PLAY TRACK MUTE ON" will be displayed, and tracks that cannot be played back will be forcibly muted. • If you wish to monitor a track that has been forcibly muted, you must first turn muting on for other tracks, and then defeat muting for the desired track. If you simply attempt to defeat muting without increasing the number of muted tracks, a message of "CANNOT CHANGE MUTE" will appear, and muting cannot be defeated. • By pressing the [ALL SAFE] key you can cancel the record-ready and muted status of all tracks. • The mute on/off setting of the tracks does not affect the [ON] keys of the monitor channels. F I (input monitor) This column indicates the signal that can be monitored for each track. The track input signal is being monitored when q is displayed, and the track playback signal is being monitored when O is displayed. The INPUT MONITOR 9 setting, the state of the [REC TRACK SELECT] key, and the current transport mode will determine which signal is being monitored for each track. G Track view The regions (continuous audio data recorded in a single operation) included in each track are displayed as bar graphs in this area. The vertical line in this area indicates the current location. The symbols displayed at the bottom of the frame indicate locate points or markers that have been set in those locations. The following types of symbols are displayed. • S Start point • E End point • I In point • O Out point • A A point • B B point • 1-99 Markers 1-99 TRACK screen H ALL MUTE OFF button This button defeats muting for all tracks. Tracks that have been forcibly muted due to limitations on the number of simultaneously playable tracks cannot be un-muted. I INPUT MONITOR Select one of the following three buttons to select the input mode (monitor source selection) for each track. The following table shows how the track monitor signal will change according to the state of the [REC TRACK SELECT] key and the transport mode when each mode is selected. q When the AUTO button is on (Auto Input Monitor) Stopped Playing Recording REC TRACK SELECT Monitored signal Off Silence On Input source Off Playback On Playback Off Playback On Input source The input mode of all tracks will change automatically depending on the on/off status of the [REC TRACK SELECT] key. It is not possible to change 6 input monitor manually. q When the INDI. button is on (Individual Input Monitor) Stopped Playing Recording REC TRACK SELECT Monitored signal (irrelevant) Input source or silence (*1) (irrelevant) Input source or playback (*1) (irrelevant) Input source or playback (*1) *1. Depends on the 6 input monitor setting. You can manually change the 6 input monitor for each track. This is unaffected by the on/off status of the [REC TRACK SELECT] key. Even for tracks whose 6 input monitor is set to the input source (q), turning on a [REC TRACK SELECT] key that had been off will automatically cause the input source (q) to switch to playback (O). TRACK 91 - Reference Guide