Yamaha DTX500K Owner's Manual - Page 18
Click Out Select, Completed, UTIL1, Hi-hat, HHofs, Click, OutSel=mix
View all Yamaha DTX500K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
3 Playing Along With the Click 8 Save an Original Click Set After creating your own original Click Set, save it in the DTX500's memory using the Store Operation described below. NOTICE • Any changes made to the data will be lost if another Click Set is selected before carrying out the store operation. If you want to keep settings or changes, make sure to carry out the Store Operation. 8-1. Press the [SAVE/ENTER] button. The following display will appear. Store Destination CLK~save~to~1 :[User~~] Click Set Name 8-2. Rotate the jog dial to select the destination memory number (1 to 30) to which you want to store the Click Set. 8-3. If you want to change the Click Set name, press the [] buttons to move the flashing cursor to the character you want to edit, then rotate the jog dial to select the desired character. A Click Set name can contain a maximum of six characters, and these can be selected from the following list. space 0123456789:;?@ ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_` abcdefghijklmnopqrstuvwxyz{|}≥≤ 8-4. Press the [SAVE/ENTER] button again. A prompt appears asking you to confirm the Store operation. CLK~save~to~1 ~Are~you~sure~? 8-5. Press the [SAVE/ENTER] button to actually execute the Store operation. * To cancel the Store operation, press any button except for the [SAVE/ENTER] and [SHIFT] buttons. (When "Are you sure?" appears in the display, the jog dial will also cancel the operation.) The following display appears after the Store operation is complete. ~~~Completed! NOTE • You can use the Factory Set operation to reset the click sets 1 through 30 to their original factory condition. However, please proceed with caution because carrying out this operation will rewrite the DTX500's entire contents (all Click Sets, User Trigger Setups 8-11, User Drum Kits 51-70, User Songs 64-83, Utility settings) with the data that was set in the unit's memory when it was shipped from the factory (p. 33). Click Out Select The DTX500 lets you select from which output jack the signal of the click (metronome) is sent. Click output and performance output can be routed to separate outputs. Operation 1. First, press the [SHIFT] + [SAVE/ENTER] buttons to call up the Utility display. UTIL1~Hi-hat HHofs=~~0~T=~~5, 2. Next, press the [>] button twice to call up the following display. UTIL2~Click "OutSel=mix~~~~, 3. Rotate the jog dial to select the output from the outputs listed below. mix This is the standard output setting. The click signal is output from both the OUTPUT L and R jacks. clickL The click signal is output from the OUTPUT L jack only. All drum performance and song playback are output in mono via the OUTPUT R jack. clickR The click signal is output from the OUTPUT R jack only. All drum performance and song playback are output in mono via the OUTPUT L jack. * The PHONES jack outputs the same signal as the OUTPUT jacks. The settings in this section would then also be applied to the PHONES jack's stereo L and R. 18 DTX500 Owner's Manual