Yamaha HTR-5460 Owner's Manual - Page 21
SUBWOOFER jack, including the YAMAHA Active Servo Processing
View all Yamaha HTR-5460 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
INTRODUCTION Main speakers A CONNECTIONS Main speakers B Right Left (U.S.A. model) VD V/CBL R+ A ITOR UT COMPONENT VIDEO MONITOR OUT MAIN B VIDEO CENTER + S VIDEO R+ SUB WOOFER OUTPUT REAR (SURROUND) SPEAKERS - - - - - +L +L Right Left AC OUTLETS SWITCHED 100W MAX. TOTAL IMPEDANCE SELECTOR SET BEFORE POWER ON MAIN A OR B: 4 MIN. /SPEAKER A + B: 8 MIN. /SPEAKER CENTER : 6 MIN. /SPEAKER REAR : 6 MIN. /SPEAKER MAIN A OR B: 8 MIN. /SPEAKER A + B:16 MIN. /SPEAKER CENTER : 8 MIN. /SPEAKER REAR : 8 MIN. /SPEAKER PREPARATION BASIC OPERATION ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX Subwoofer Center speaker system Right Left Rear speakers s SUBWOOFER jack When using a subwoofer with built-in amplifier, including the YAMAHA Active Servo Processing Subwoofer System, connect the input jack of the subwoofer system to this jack. Low bass signals distributed from the main, center and/or rear channels are directed to this jack. (The cut-off frequency of this jack is 90 Hz.) The LFE (low-frequency effect) signals generated when Dolby Digital or DTS is decoded are also directed if they are assigned to this jack. Notes • Adjust the subwoofer volume according to the operating instructions for the subwoofer. (Fine adjustment is possible using this unit's output level control of the effect speakers.) • Depending on the settings of "1 SPEAKER SET", "6 DOLBY D. SET" and "7 DTS SET" on the SET MENU, some signals may not be output from the SUBWOOFER jack. 17 English