Yamaha HTR-5460 Owner's Manual - Page 65

INTRODUCTION PREPARATION TROUBLESHOOTING Problem Cause The volume level cannot be increased, or the sound is distorted. The effect and surround sounds cannot be recorded. The component connected to the REC OUT jacks of this unit is turned off. It is not possible to record the effect and surround sounds by a recording component. A source cannot be recorded by a digital recording component connected to the DIGITAL OUTPUT jack of this unit. A source component is only connected to the analog input jacks of this unit. The sound field parameters and some other settings on this unit cannot be changed. "10 MEMORY GUARD" on the SET MENU is set to ON. When TUNER is selected, the DSP program name shown on the display immediately changes to the frequency. This unit does not operate properly. The OSD mode is set to short display or display off. The internal microcomputer has been frozen by an external electric shock (such as lightning or excessive static electricity) or by a power supply with low voltage. The sound is degraded when listening with headphones connected to a tape deck or CD player that is connected to this unit. There is noise interference from digital or highfrequency equipment, or the unit. This unit is in the standby mode. The unit is too close to the digital or highfrequency equipment. Remedy Turn on the power to the component. Connect the source component to the digital input jacks of this unit. Select OFF. If you want the DSP program name display to be shown constantly, set the OSD mode to full display. Disconnect the AC power cord from the outlet and then plug it in again after about 30 seconds. Turn on the power of the unit. Move the unit further away from such equipment. Refer to page 12 34 12 - 15 41 19 - - - BASIC OPERAIONT ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 61