Yamaha HTR-5460 Owner's Manual - Page 25

INTRODUCTION PREPARATION BASIC OPERAIONT ADJUSTING THE SPEAKER OUTPUT LEVELS This section explains how to adjust the speaker output levels by using the test tone generator. When this adjustment is made, the output level heard at the listening position will be the same from each speaker. This is important for the best performance of the digital sound field processor, the Dolby Pro Logic decoder, Dolby Digital decoder and DTS decoder. Note • Since this unit cannot enter the test mode while headphones are connected to this unit, be sure to unplug the headphones from the PHONES jack when using the test tone. Using the Test Tone (TEST DOLBY SUR.) The adjustment of each speaker output level should be made at your listening position with the remote control. 2,6 1 A/B/C/D/E 5 4 Before You Begin 1 STANDBY /ON D I G I TA L SURROUND BASS EXTENSION BASS TREBLE ON OFF -+ -+ SPEAKERS A B ON OFF D I G I TA L VOLUME EFFECT DSP PROGRAM PRESET /TUNING FM/AM MEMORY TUNING MODE EDIT PHONES S VIDEO VIDEO L AUDIO R OPTICAL MAN'L/AUTO FM AUTO/MAN'L MONO SILENT VIDEO AUX INPUT MODE INPUT 6CH INPUT 33 2 1 Press STANDBY/ON to turn on the power. Turn on the video monitor. STANDBY /ON 2 Press SPEAKERS A or B to select the main speakers to be used. If you are using two sets of the main speakers, press both A and B. SPEAKERS A B ON OFF 3 Set BASS and TREBLE on the front panel to the center position and set BASS EXTENSION to OFF. BASS EXTENSION BASS TREBLE 3 A/B/C/D/E 1 Set the selector dial to the AMP/TUN (or DSP/TUN) position. 2 Press TEST to output the test tone. 3 Adjust the volume so you can hear the test tone. The test tone is heard from the left main speaker, center speaker, right main speaker, right rear speaker and left rear speaker in order. The tone is produced for 2.5 seconds each time. LEFT RIGHT (TEST LEFT) (TEST RIGHT) CENTER (TEST CENTER) ON OFF Set to OFF. -+ -+ LEFT SURROUND RIGHT SURROUND (TEST L SUR.) (TEST R SUR.) ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 21