Yamaha MT4X Owner's Manual - Page 13
Front Panel Connections - tape speed
View all Yamaha MT4X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
11 Controls and Connections Y Tape counter This indicator displays tape position. Z Level meters These indicators display the signal level within a range of -20 dB to +9 dB. The individual tracks and the stereo bus are displayed. • When dbx™ is off, the normal signal limit is approximately 0 dB. • When dbx™ is on, the normal signal limit is approximately +6 dB. Note: The meters can be switched to peak hold. To switch peak hold on or off, press the COUNTER RESET key (Q) while holding down the STOP key (W). [ Tape speed indicator These indicators show the current tape speed selection, either 9.5 cm/sec or 4.8 cm/sec. When the MT4X is first powered on, it defaults to 9.5 cm/sec. \ dbx indicator This indicator illuminates when the dbx™ noise reduction system is turned on. ] SYNC indicator This indicator illuminates when SYNC key (K) has been switched on. ^ AUTO PUNCH indicators These indicators show the status of the automatic punch-in/out function. See "Using the automatic punch-in/out function" on page 21. a MEMO indicators These indicators illuminate when their respective memory points have been set. b REPEAT indicator This indicator illuminates while the repeat function is active. c REC SELECT - TRACK indicators These indicators flash when you arm the corresponding track by pressing one of the REC SELECT keys (G). The armed indicators switch from flashing to illuminated when you press the REC/ PAUSE key (S). Front Panel Connections d PHONES connector This 1/4" phone connector is used for a pair of stereo headphones (8 Ω to 40 Ω). e PUNCH I/O footswitch connector This connector is used to plug in an optional footswitch (FC5) for punch-in/out recording. See "Using the optional footswitch" on page 28. PHONES d PUNCH I/O e User's Guide