Yamaha RX-V4A RX-V4A User Guide - Page 77

PREPARATIONS > Configuring the speaker settings Warning messages from YPAO If a warning message is displayed, resolve the problem by following table and perform YPAO again. You can still apply the measurement results, however, we recommend you resolve the problem and perform YPAO again in order to use the unit with the optimal speaker settings. Warning message W-1:Out of Phase W-2:Over Distance W-3:Level Error Remedy Check the cable connections (+/-) of the corresponding speaker. If the speaker is connected incorrectly: Reconnect the speaker cable. If the speaker is connected correctly: Depending on the type of speakers or room environment, this message may appear even if the speakers are connected correctly. In this case, you can ignore the message. (This message is displayed to suggest confirmation to you, and it doesn't influence the playback of the unit.) Place the corresponding speaker within 24 m (80 ft) of the listening position. Correct the cable connection or position of the corresponding speaker. We recommend using the same speakers or speakers with specifications that are as similar as possible. Confirm the appropriate volume to the subwoofer with a problem. NOTE Correct the cable connection or position of the speaker after turning off the unit. 77